Tag Archives: hurricane proof

Full Foundation, Hurricane Proof, and Drill-Set Brackets on Slab

This Wednesday the Pole Barn Guru answers reader questions about a village or township requiring you to put a full foundation in for a pole building, whether a pole building is “hurricane proof,” and the potential use of drill-set brackets to set 6×6 columns on an existing slab with thickened edge.

DEAR POLE BARN GURU: Can a village or township require you to put a full foundation in for a pole building? CHRISSY in CHANNAHON

DEAR CHRISSY: Our country has two model Building Codes – IRC (International Residential Code) for one and two family dwellings and their accessory structures, and IBC (International Building Code) for all other buildings. Neither code has a requirement for full foundation to support pole (post frame) buildings. I would encourage you to reach out to your local Building Official to ask for further information – it is possible your village or township may have enacted a specific ordinance, to this case, if so – request a written copy of the approved document and please forward it to me for review. In most instances, no such ordinance exists and, if so, this ‘requirement’ cannot be legally enforced.

 

DEAR POLE BARN GURU: Are they hurricane proof? LINDAONGLEY in DAVENPORT

DEAR LINDA: I don’t know of any structural system other than maybe a reinforced concrete building underground and above any flood stage affording 100% hurricane protection. We can engineer to design wind speeds in excess of 200mph.

 

DEAR POLE BARN GURU: I have a new monoslab with 20″ footer all around. Slab is also reinforced with 1/2″ rebar. I want to build a 40’x46′ pole barn. Walls are 14′, roof trusses are 5/12 pitch. Can I use Simpson brackets and place 6″x6″ posts on top of the concrete every 8′ with 2″x6″ girts? Or should I have builder put posts in the ground around the slab? Thanks-ERIC in REXFORD

DEAR ERIC: There is no dry set (bolted down) anchor (including those from Simpson) capable of handling even minimal moment (bending) loads. So no – you should not use any type of bracket on top of your slab. Your best bet will be to build around slab with posts properly embedded in ground.