Putting Everything Under One Post Frame Roof

Putting Everything Under One Post Frame Roof

I have been an advocate of one larger roof, rather than an enclosed building with a roof only side shed for years. This allows for greater headroom in ‘shed’ area without having to deal with pitch breaks (transition from a steeper slope main roof to a flatter shed roof), making for easier assembly. In almost all instances, this will result in a less costly design solution.

This also happens to be a lesson I have tried to impart upon our Hansen Pole Buildings’ Design Team, however they have been slow to embrace this concept.

Reader RYAN in SUN RIVER writes:

Hansen Pole RV Storage“I have plans to build a 52x48x14 this spring.  The idea is 52×48 roofline 4/12 pitch. Under that roof is a 16×48 open side for rv parking and then 36×48 enclosed with concrete floor.  My original thoughts are to 2×6 stick frame the wall separating the open area from the enclosed area after the pad is poured (any suggestions). 16×12 insulated door and a 4’ man door on the front gable end and a 3’ man door to get in from under the open area towards the rear.

How much would you charge to draw this up with your building techniques?  

I am planning on sourcing materials local but wouldn’t mind a quote from you either.”

I do like your idea of having your enclosed portion and roof only under one gabled roof, rather than a smaller gable over enclosed portion and balance as a shed roof off one side. You gain headroom, it is easier to assemble and usually less costly.

I would frame separation wall with wall girts, rather than stick framing and having to add on horizontal framing to attach wall steel. Code also will not allow for a stud framed wall greater than 10 feet in height without it being engineered. To minimize possibilities of water from your RV area migrating into enclosed areas, your concrete should be two separate pours, with RV parking slab slightly lower at main building wall and sloping away from it.

Your choice of having a four foot wide person door is one you will not regret. For a minimal added investment you will save your knuckles repeatedly. 

As for building plans, we are not a plans’ service, however your investment in a new Hansen Pole Building does come with complete third-party engineer sealed structural plans, along with verifying calculations. This alone will usually save you thousands of dollars in engineering costs, plus you have our roughly 20,000 buildings of experience to arrive at what will be your most practical and cost efficient design.

Why people think they are somehow going to get a “better deal” by sourcing materials locally is beyond my comprehension. We have buying power an average individual (or contractor even) is never going to have, plus our control over materials being provided allows our engineers to be certain what they specify on plans, gets delivered to your building site. Some materials we have produced only for our clients – you cannot buy them elsewhere. 

For continued reading on this subject: https://www.hansenpolebuildings.com/2014/03/diy-pole-building/

Leave a Reply

Your email address will not be published. Required fields are marked *

What will you use your

building for?


Select a building use to get started on your Free Building Quote

Approximate

Building Dimension


A building can be a tough decision. Call 866.200.9657 for a free consultation now!

Your Building. Your Way.

A building can be a tough decision. Call 866.200.9657 for a free consultation now!

Your Building. Your Way.


A building can be a tough decision. Call 866.200.9657 for a free consultation now!

1.866.200.9657
Building KitPrice

Know more about our pricing..

Pole Barn Guru Blog

The industry’s most comprehensive post frame blog.

Ask The Guru

This guru will grant you the answer to one pole barn question!

Pole Building Learning Center

to help guide you in the design of your new pole building

Photo Gallery

Look at our collection of building photos for creative ideas!

Paint Your Building

Lets pick out some colors!