Termites and Pole Barns

Pole Barn Guru Blog

A Buggy Situation

A client writes to Justine (the Hansen Pole Buildings’ Order Fulfillment goddess) this week:

termites“I was hoping to get some advice.  I’m still working on the building having just completed rafter placement and was starting to pull apart the two bundles of lumber for the purlins.  When I started pulling boards out of the bundle I noticed some surface damage that just kept getting worse as I sent through the stack of lumber.  Toward the center there was a large amount of termites, see pictures.  The odd thing was it only affected the stack of 2X6X10′ boards, the other bundle of lumber, sitting right next to it was untouched.  This is really unusual for our area where summers are hot 90-100° with very low humidity <15-20% making termites a very rare issue.  The lumber was stored as instructed in your manual but now we have a probably 1/2 of the 2X6X10′ boards that are damaged significantly.  Since termites are not a large problem in this area and all of the infestation was in the center of a stack of very wet wood (not from any rain or external water) and there was no damage to the stack sitting next to it, I suspect it came with termites but of course I can’t prove that so as disappointed as I am let me get on to the request for advice.  These boards are primarily used for the purlins and horizontal siding support around the outside of the building.  I know the purlins are structural and need to be 100% clean wood, but is some level of damage acceptable for the horizontal boards between the posts?  If so, how much, or is any penetration by the termites into the wood render it unusable? “ 

Personally, I feel bad for the client, however he did take delivery of the materials back in April and on May 3 he wrote to Justine:

“I have all of the material and all is in good shape.  Thank you for all of your support”

On one hand client has received everything in good order, on the other hand nearly four months later there are some challenges. It is possible the lumber was shipped buggy – wildly random things do happen. It is also possible the material got wet in the spring and the heat from the 90-100 degree summer days caused the relative humidity in the center of the unit to increase as the unit was likely paper wrapped. In either case, it ended up as the perfect breeding ground for pesky little critters.

The lumber grading rules are fairly generous about allowable defects, so some of the damaged materials may be able to be used.

Here was Justine’s response (spot on by the way):

lumber damage“We would happy to provide some advice for this situation. Let me first say this is why we stress so much to inspect and inventory wood as they arrive up front. You are probably correct in your conclusion they came with the mites in the bundle. If the bundle would have been opened then we could have probably avoided your current situation.

To answer your question, yes there are some level of acceptable defects in lumber. Keep in mind the wall girts are just as crucial as the roof purlins in supporting the loads of your building.

You can read about these allowable lumber defects on our blog: https://www.hansenpolebuildings.com/2013/12/lumber-defects/


I would generally apply some common sense on how I use certain boards and which ones I decide not to use. I would say first take the boards you deem usable but in the worst shape in locations which don’t provide as much structural value like in blocking locations. For girts and purlins they don’t need to be perfect but anything meeting the allowable defect rules it will work for those locations but I would try to keep the better boards for those two locations. Anything which does not meet the minimum requirements will have to be replaced.”

Moral of the story – regardless of whom you buy your building from, or where the lumber came from, inspect it thoroughly at time of delivery for defects as well as surprises. This allows for anything out of the ordinary to be taken care of promptly, before feelings get hurt. And, always try to use materials as expediently as possible, the sooner they become part of your new post frame building, the happier they will be.

Leave a Reply

Your email address will not be published. Required fields are marked *

What will you use your

building for?


Select a building use to get started on your Free Building Quote

Approximate

Building Dimension


A building can be a tough decision. Call 866.200.9657 for a free consultation now!

Your Building. Your Way.

A building can be a tough decision. Call 866.200.9657 for a free consultation now!

Your Building. Your Way.


A building can be a tough decision. Call 866.200.9657 for a free consultation now!

1.866.200.9657
Building KitPrice

Know more about our pricing..

Pole Barn Guru Blog

The industry’s most comprehensive post frame blog.

Ask The Guru

This guru will grant you the answer to one pole barn question!

Pole Building Learning Center

to help guide you in the design of your new pole building

Photo Gallery

Look at our collection of building photos for creative ideas!

Paint Your Building

Lets pick out some colors!