Tag Archives: concreting pole barn holes

Are the Poles Close Enough?

Welcome to Ask the Pole Barn Guru – where you can ask questions about building topics, with answers posted on Mondays.  With many questions to answer, please be patient to watch for yours to come up on a future Monday segment.  If you want a quick answer, please be sure to answer with a “reply-able” email address.

Email all questions to: PoleBarnGuru@HansenPoleBuildings.com

DEAR POLE BARN GURU:How close is close enough for pole placement? After setting and leveling poles to the string, the poles on one side of the barn are 1/2″ off (lengthwise) from the other side. Is this close enough? KARMIC IN KANSAS CITY

DEAR KARMIC: There actually exists a document entitled, “Accepted Practices for Post-Frame Building Construction: Framing Tolerances”. In the document, in Section 6.4: “Wall length. In rectangular buildings, the overall length of opposing walls should not differ by more than 2.0 inches.”

In my humble opinion “only” two inches would be a HUGE difference. Variations such as this need to be hidden somewhere and two inches would be huge.

In your particular case, if the poles are merely placed in the holes and braced, I would recommend adjusting a corner column to get equal overall lengths.

If the columns have been set in concrete, it is best to then make the overall dimensions at the roofline correct. This will make squaring up the roof to install roofing far easier. In the event this circumstance is the choice, when it comes time to do the siding, plumb the corner(s) which are most likely to be noticed.

On the out-of-plumb corners, the edge of the corner trim will not align with the steel ribs (there will be a ½ inch variation from top to bottom). Most people will never see it – but putting it on the least viewed corner reduces the probability.

DEAR POLE BARN GURU: Hi: How do I install fiberglass batts of R 19 in my walls of pole barn without touching the metal walls? Thanks. ART IN ALBION

DEAR ART: The easiest way would be to install a quality housewrap over the outside of the wall girts and under the wall steel before siding it.

In the event your pole building has been sided, there really is not a negative effect in the event the fiberglass happens to be in contact with the wall steel. It IS essential to have a vapor barrier on the inside of the insulation which provides a total seal. If the vapor barrier is not completely sealed moisture will escape into the wall cavity, and be trapped by the steel siding. When the siding is cold enough, condensation will form, saturating the fiberglass and reducing its efficiency.

You may want to read more on climate controlled pole buildings at:

https://www.hansenpolebuildings.com/blog/2012/04/climate-controlled/

DEAR POLE BARN GURU:What about putting the concrete up to the slab level?

CONCRETING IN CANTON

DEAR CONCRETING: I will assume your question is in regards to backfilling the columns. If so, there is no documented negative reason (lots of old wives’ tales) to not fill the holes entirely with concrete – other than cost (concrete can become expensive backfill). It will make your building very resistant to uplift forces.